137335 Pre-owned Iowa Precision Plasma Coil Feed

In Stock

Pre-owned Iowa Precision Plasma coil feed for plasma cutting system.

• Max. Gauge Capacity: 16 GA
• Max. Width Capacity: 60″
• Pass Line Height: 32.5″
• Speed: 65 FPM
• Motor/Voltage: 5HP, 230/460 volts, 60 cycle, 3 phase
• Dimensions/Weight: Length 13’4″, Width: 77″, Height: 26′ 8″, Weight: 3,900 lbs for two uncoilers/7,800 lbs for four uncoilers

The Iowa Precision Coil Feed Machine for Plasma and Laser Cutting Tables is comprised of a drive motor and a series of rolls to feed and remove coil set from the material. The operator uses an on/off switch attached to an electrical cable to advance the material. This allows the operator to feed the material to the proper location along the plasma table. Drive is by way of entry and exit pinch rolls and straightening is accomplished with a fifth roll, which is located between the entry and exit rolls. This straightening roll is controlled by a hand wheel to vary the amount of flattening. Plasma or laser cut-off of the sheet length is standard and an optional shear cut-off system is also available.